Black Friday Bonus: Buy a New System ($15K+) & Get a $500 Visa Gift Card

A boiler heats water and circulates it to radiators or baseboard. A furnace heats air and blows it through ducts. Neither one is better across the board. In most Boston homes, the right choice is the system the house was built around, because adding ducts or removing radiators is the biggest part of any switch.

How a boiler heats a home

A boiler uses natural gas, oil, or electricity to heat water. A circulator pump sends the hot water through pipes to radiators, baseboard, or tubing under the floor, then back to the boiler to be reheated. Some older homes have a steam boiler, which sends steam up to the radiators instead of hot water.

Radiators give off heat slowly. They warm the walls, floors, and furniture along with the air, so rooms stay comfortable for a while after the boiler shuts off.

How a furnace heats a home

A furnace uses natural gas, oil, or electricity to heat air. A blower pushes that air through supply ducts to the vents in each room, and return ducts bring cooler air back to the furnace.

Rooms warm up quickly, the air passes through a filter on every cycle, and the same ducts can carry central A/C in the summer.

Boiler vs. furnace: side-by-side comparison

BoilerFurnace
How heat movesHot water or steam through pipesWarm air through ducts
How the heat feelsSteady, even, and quietQuick, with air movement
Warm-up timeSlowerFaster
Air filtrationNone built inFilter on every cycle
Winter airDoesn’t dry out the airCan dry out the air
Central A/CNeeds a separate systemShares ductwork with A/C
Tap waterCan heat it with an indirect tankNeeds a separate water heater
What it takes upRadiators or baseboard along wallsVents, plus ducts in walls and ceilings

Why older Boston homes usually have boilers

Much of Boston’s older housing, including triple-deckers, Victorians, and early colonials, was built with steam or hot water radiators and no ductwork. Fitting ducts into finished plaster walls is a major project, so owners of these homes almost always replace an old boiler with a new one.

Homes built in later decades are more likely to have ductwork and a furnace.

When a boiler is the better choice

  • Your home already has radiators or baseboard in good shape.
  • You want quiet, even heat without air blowing through the room.
  • You’d like one appliance that also heats your tap water.
  • You don’t want to open walls and ceilings to add ducts.

When a furnace is the better choice

  • Your home already has ductwork in good condition.
  • You want central A/C that runs through the same ducts.
  • You prefer fast heat and filtered air.
  • You plan to add a whole-home humidifier or air cleaner to the ducts.

Adding A/C to a home with a boiler

A home with a boiler has no ducts for central air, but that doesn’t rule out cooling. A ductless mini-split system places a small indoor unit in each room or zone and connects to an outdoor unit through a small hole in the wall. A high-velocity system runs small, flexible tubes through the walls with very little demolition.

Most homeowners in this situation keep the boiler for heat and add one of these for summer.

Is it worth switching from a boiler to a furnace?

Switching from a boiler to a furnace usually makes sense only when you also want central A/C and you’re already opening walls for a renovation. Otherwise, replacing a boiler with a boiler keeps the job smaller and keeps the kind of heat you’re used to.

Before you decide, look at:

  1. The condition of your current pipes and radiators
  2. Any usable ductwork already in the house
  3. Renovations you’re planning in the next few years
  4. The fuel you have available, such as a gas line or an oil tank

Boiler and furnace installation in Boston

Sila installs, repairs, and maintains both systems in homes across Boston, so the recommendation you get is based on your house, not on what we’d prefer to install. See our boiler services, furnace services, and heating installation pages, or schedule a walkthrough of your home.

Boiler vs. furnace FAQs

Is a boiler or a furnace better for an older home?

A boiler is usually the better fit for an older home that already has radiators or baseboard, because the piping is in place and no ductwork has to be added. A furnace is the better fit when the house already has ducts in good condition.

Is a boiler or a furnace more efficient?

A boiler and a furnace can be equally efficient, because both come in high-efficiency condensing models. The bigger difference is often delivery: a furnace connected to leaky ducts in an unheated attic or basement loses heat before it reaches the room, while a boiler’s pipes lose very little.

Which is quieter, a boiler or a furnace?

A hot water boiler is usually quieter than a furnace, because there’s no blower pushing air through ducts. A steam system can knock or hiss, which usually points to a piping or venting problem a technician can correct.

Can a home have both a boiler and a furnace?

A home can have both a boiler and a furnace, with each one heating a different part of the house. Another option, called hydro-air, uses a boiler to heat water that runs through a coil in an air handler, which gives the home forced-air heat through ducts that can also carry central A/C.